SequenceMix 2892E
3U Eurocard Rack compatible format:
- 26HP width with Bantam/TT 4.4mm (ET) or mini-jack (EJ) sockets
- 120mm deep (140mm with power connector)
(Other panel formats may be custom ordered.)
Features:
- Precision voltage reference with 3ppm/°C temperature coefficient.
- Low noise, precision DC mixers.
- Socketed ICs.
- High quality long life sealed conductive plastic pots.
- 2.5mm anodised aluminium panel.
- Re-wireable connectors.
I/O:
- 10 x balanced/unbalanced DC-coupled inputs. 100k ohm input impedance.
- 1 x balanced/unbalanced DC-coupled reference input option. 12k5 ohm input impedance.
- 13 x balanced/unbalanced DC-coupled outputs, very low output impedance.
Signal Levels:
- ±9V maximum on ±12V power
- ±12V maximum on ±15V power
- Shift Input threshold: 1.6V
- Clock Input threshold: 3.3V
- Noise margin: 0.4V
- Shift Output and Step Clock level: 0-5V or 0-10V, set by links
Distortion:
Frequency Response:
- DC–20kHz < ±0.5 dB
- 33kHz -3 dB
Noise Floor:
DC Accuracy:
- Offset: < 2mV
- Gain Error: < 0.25% (3 cents per octave)
Timing:
- Analogue Clock rising edge to switch change: 25 to 55 μs
- MIDI Clock or Note On/Off end to switch change: 25 to 55 μs
- Step Clock pulse width: 1ms
Software:
- Version 1.01, November 2020
Connectors:
- DB25 AES59 (Tascam) analogue pinout for switch inputs and outputs
- Molex KK 0.1" for all other jacks
- 4.4mm (TT Bantam) jack (balanced) or mini-jack (unbalanced)
Power:
- +/-12V to +/-15V
- Quiescent current: 110 mA (typical), 150mA maximum LEDs on.
- Reverse and over voltage and over current protection.
-
10 pin MFJ power connector.
N.B. A suitable MFJ-10 power cable is supplied for connection to our Busbars or Euro 16-pin headers.
- High Quality Linear mains PSU available. N.B. The above specification cannot be guaranteed when run on other PSUs, especially switch mode types.
