Output Line Driver

Signal Matrix

 

Specifications

 
Signal Matrix (side)

Signal Matrix 2422E

3U Eurocard Rack format:
  • 8HP width with Bantam TT sockets
Profile:
  • 160mm deep (180mm with power connector)

(Note: this module will not fit in shallow Eurorack cases.)

 
Features:
  • High quality long life sealed conductive plastic pot.
  • 25 turn calibration trimmers.
  • Socketed ICs.
  • 2.5mm anodised aluminium panel.
  • Rewireable connectors.
I/O:
  • 4 x balanced/unbalanced DC coupled inputs, 100k ohm input impedance.
  • 4 x balanced/unbalanced DC coupled outputs, very low output impedance.
Signal Levels:
  • ±9V (+18dBu) on ±12V
  • ±10V (+19.5dBu) on ±15V
Distortion:
  • <0.02% @ 1 kHz, +17 dBu
Frequency Response:
  • DC–20kHz < ±0.5 dB
  • 90kHz -3 dB
Noise Floor:
  • < -80 dBu (unweighted)
Connectors:
  • Molex KK 0.1" internal headers
  • Front Panel 4.4mm (TT Bantam) jack (balanced)
Power:
  • +/-12V to +/-15V
  • Current with large signals: 30 mA @ 12 V, 35 mA @ 15 V
  • Reverse and over voltage and over current protection.
  • 10 pin MFJ power connector.
    N.B. A suitable MFJ-10 power cable is supplied for connection to our Busbars or Euro 16-pin headers.
  • Mains Linear Power Supply N.B. The above specification cannot be guaranteed when run on other PSUs, especially switch mode types.
 
 
Last updated: 31 October 2021