Gate Logic

Gate Logic

 

Specifications

 
Gate Logic
 

Gate Logic

3U Eurocard Rack compatible format:
  • 8HP width with Bantam/TT 4.4mm (ET).
  • 160mm deep.
  • Optional 6HP width panel for DIN connectors and Footswitch jack, may be placed away from main panel.
 
Features:
  • Three analogue inputs, ±15V signals.
  • Three analogue logic outputs, +5V or +10V selectable level.
  • Socketed DIL ICs, no SMD, for field serviceability.
  • 2.5mm anodised aluminium panel.
  • Re-wireable connectors on plug in headers.
  • Proprietary low noise LED drivers.
I/O:
  • 3 x balanced/unbalanced DC-coupled inputs, 100k ohm input impedance.
  • 3 x balanced/unbalanced DC-coupled outputs, with series diode outputs for wire-OR.
Input Signal Levels:
  • ±15V (+22dBu) maximum
  • Gate threshold: +1.6V
  • Trigger threshold: +3.3V
Output Signals:
  • LFO, manual Gate and logic Q: 0 - +5V or +10V.
Propagation Delay:
  • A or B change to Q change: 20 - 40µs.
LFO:
  • Lowest frequency: 0.12mHz (>2.3hours).
  • Highest frequency: 999.99Hz.
MIDI
  • All Real Time messages on MIDI In are repeated on MIDI Out (soft Thru).
  • Messages recognised: Note On/Off and Program Changes.
  • Messages generated: Note On/Off, GP1 Controller.
Connectors:
  • Front Panel 4.4mm (TT Bantam) jack (balanced)
  • Molex KK 0.1" internal headers
  • DIN 41524 metal connectors for MIDI
Power:
  • ±12V to ±15V
  • Quiescent current: 90 mA (typical)
  • Reverse and over voltage and over current protection.
  • 10 pin MFJ power connector.
    N.B. A suitable MFJ-10 power cable is supplied for connection to our Busbars or Euro 16-pin headers.
  • Optional mains PSU available.
 
 
Last updated: 02 April 2024