Output Line Driver 2733E
3U Eurocard Rack format:
- 8HP width with Bantam TT sockets
Profile:
- 160mm deep (180mm with power connector)
(Note: this module will not fit in shallow Eurorack cases.)
Features:
- High quality long life sealed conductive plastic pots.
- 25 turn calibration trimmers.
- Bi-colour LED indication of output signal.
- Socketed ICs.
- 2.5mm anodised aluminium panel.
- Rewireable connectors.
I/O:
- 3 x balanced/unbalanced DC servo-ed inputs, 100k ohm input impedance.
- 4 x balanced/unbalanced DC servo-ed outputs, very low output impedance.
- 1 x stereo headphone output, 470 ohm output impedance. Will drive 8 - 400 ohms.
- Stereo link between module outputs.
Signal Levels:
-
±9V (+18dBu) on ±12V
-
±10V (+19.5dBu) on ±15V
Distortion:
- Compressor out: <0.02% @ 1 kHz, +17 dBu
- Compressor in: 1% to 20%
Frequency Response:
- DC–20kHz < ±0.5 dB
- 90kHz -3 dB
Noise Floor:
- < -86 dBu (unweighted)
- Mute: -93 dBu (30 kHz filter)
Connectors:
- Molex KK 0.1" internal headers
- Front Panel 4.4mm (TT Bantam) jack (balanced)
- Headphone: 3.5mm stereo.
Power:
- +/-12V to +/-15V
- Quiescent current: 70 mA (typical)
- Current with large signals: 100 mA @ 12 V, 120 mA @ 15 V
- Reverse and over voltage and over current protection.
-
10 pin MFJ power connector.
N.B. A suitable MFJ-10 power cable is supplied for connection to our Busbars or Euro 16-pin headers.
- Mains Linear Power Supply N.B. The above specification cannot be guaranteed when run on other PSUs, especially switch mode types.
